Sparkle ATX-450PN-B204 450W ATX 12V v2.2 Power Supply

Specifications

• Mfr Part Number: ATX-450PN-B204
• Features:
  • Complied with ATX12V standard
  • High efficiency and reliability, low noise and ripple
  • Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances)
  • Remote ON/OFF function
  • Internal 12V DC fan included
  • Noise Killer (thermal fan speed control function)
  • Output over voltage, short circuit, and over current protection
  • 100% Hi-pot, ATE, and burn-in tested
  • Re-settable power shut down
  • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
  • Approved by UL60950, CSA C22.2 NO. 60950, TUV EN60950 or VDE EN60950, NEMKO EN60950 (CB Report)
• Total Power: 450 W
• Type: ATX from factor 12V v2.2
• Input:
  • Input Range: ±10% of 115Vrms/57~63Hz or 230Vrms/47~53Hz, Manual Selection
  • Input Current: 10A (RMS) @115Vac, 5A (RMS) @ 230Vac
  • Inrush Current: No Damage
• Output:
  • +3.3V @ 22A; +5V @ 15A; +12V1 & +12V2 @ 18A; -12V @ 0.3A; +5VSB @ 2.5A
  • +3.3V & +5V total output not exceed 145W
  • +12V1 & +12V2 total output not exceed 360W
  • +3.3V & +5V & +12V1 & +12V2 total output not exceed 433W
• Dielectric Withstand: Primary frame ground 1800V AC for 1 second
• Efficiency: 70% minimum measured at normal AC mains voltage and frequency with full load
• Rise time: Less than 20ms
• Hold-up Time: 12ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA at 115VAC/60Hz
• MTBF: 100,000 hours
• Connectors: 1x 20+4pin Main Connector; 1x 4pin 12V CPU Connector; 1x PCI-Express Connectors; 2x SATA Connectors; 6x Peripheral Connectors; 1x Floppy Connector
• Dimensions (WxLxH): 5.9 x 5.5 x 3.4 inch / 150.0 x 140.0 x 86.0 mm

Write a review